Cross Technologies 2016-26 Manual de Instruções

Instruction Manual Model 2016-26 Downconverter February 2009 Rev A MENUEXECUTEMODEL 2016F = 2050 G = +10.0POWERALARMDOWNCO

2.3 Front Panel Controls and Indicators - The following are the front panel controls and indicators. MENUEXECUTEF = 2050 G = +10.0REMOTE POWERLC

2.4 Installation / Operation2.4.1 Installing and Operating the 2016-26, Downconverter Section 1. Connect a -20 dBm to -140 dBm signal to RF In, J2

2.5 Menu Settings2.5.1 Functions This section describes operation of the front panel controls. There are three operator switches, the LCD display an

2.5.2. Power On SettingsNOTE: The last status of a unit is retained even when power is removed. When power is restored, the unit will return to it&

2.5.4 Frequency ChangesAt any time during the modification process, if you have made a mistake and do not wish to save the changes you have made, d

2.5.5 Gain ChangesWhen you get to this menu note that the gain changes will be made as you make them but if you do not wish to save the changes you h

2.5.5 Alarm IndicationsAn alarm condition for will occur if the local oscillator phase lock loop (PLL) comes out of lock. The Mute LED will light if

2.6 Use InformationA. Elevated operating ambient temperature - if installed in a closed or multi-unit rack assembly, the operating ambient temperatur

CROSS TECHNOLOGIES, INC.6170 Shiloh RoadAlpharetta, Georgia 30005(770) 886-8005FAX (770) 886-7964Toll Free 888-900-5588WEB www.crosstechnologies.com E

INSTRUCTION MANUALMODEL 2016-26 Downconverter TABLE OF CONTENTS PAGEWarranty 21.0 General 31.1 Equipment Description 31.2 Technical Characterist

MODEL 2016-26 Downconverter1.0 General1.1 Equipment DescriptionThe 2016-26 Downconverter converts 2000 to 2500 MHz to 140 ± 36 MHz in 1 MHz steps wi

1.2 Technical CharacteristicsTABLE 1.0 2016-26 Downconverter Specifications*Input Characteristics (RF) Impedance/Return Loss 50  /12 dBFrequency

1.3 Monitor and Control InterfaceA) Remote serial interfaceProtocol: RS-232C, 9600 baud rate, no parity, 8 data bits, 1 start bit, and 1 stop bit

B) Status Requests Table 1.1 lists the status requests for the 2016-34 and briefly describes them.* PLEASE NOTE: The two character {aa}(00-31) prefix,

C) Commands Table 1.2 lists the commands for the 2016-27 and briefly describes them. After a command is sent the 2016-27 sends a return “>” indicat

2.0 Installation2.1 MechanicalThe 2016-26 consists of one RF/Controller PCB housed in a 1 RU (1 3/4 inch high) by 16 inch deep chassis. A switching,

2.2 Rear Panel Input/Output Signals - Figure 2.2 shows the input and output connectors on the rear panel. ACGNDJ1810 MHZ REFOUTPUTJ10ANDMONITORCON