Cross Technologies 2416-x02 Manual de Instruções descarregar pdf (Página 22)

3.4 SNMP Configuration

Setting of SNMP parameters such as Community Write and Community Read strings requires a Telnet

connection to port 9999. The following instructions explain how to establish such a Telnet connection using

Windows XP's utility Hyper Terminal.

Start the Hyper Terminal application and select “New Connection” from the “File” drop down menu.

The next screen is a “Connect To” dialog box.

1. Enter the IP address of the 2416-x02 in the “Host address:” field.

2. Enter 9999 in the “Port Number:” field.

3. Select TCP/IP (Winsock) from the “Connect using:” drop down menu.

Figure 3.4 shows an example of the Hyper Terminal settings required to access the SNMP configuration menu.

Figure 3.4: Telnet

Settings in Hyper Terminal

Once the Telnet

connection is established you will be prompted to “Press Enter for Setup Mode”.

Press enter and a menu of device server configuration options will appear. Select menu item 3, “SNMP

configuration”. You will be presented with a screen like shown in Figure 3.5. You will be prompted to enter

SNMP community read and write strings.

You may select either Public or Private SNMP community read and write strings.

If you select Private you must enter at least one (1) and up to three (3) IP addresses of SNMP managers that

will access the unit. This is required even though SNMP traps are not implemented. The unit will NOT

process SNMP Set & Get commands if you do not enter least one (1) IP addresses of an SNMP manager.

2415-x02 Manual, Rev. A Page 22 02/25/15

1 2 ... 17 18 19 20 21 22 23 24

Sem comentários

Cross Technologies 2416-x02 Manual de Instruções Página 22